The functions of coolant include water quality leveling, anti-freeze, anti-rusting and water scale reducing - Coolant can effectively reduce the temperature of computer system - Protects Thermaltake cooling system metals from corrosion and cavitation including aluminum Step 1 Shut down the computer completely before filling Step 2 Use refill water tank to fill coolant into the pump Step3 Double check the water pipes and secure the terminals tightly
CAUTION: -Include coolant can only used with thermaltake liquid cooling system series products. -Do not use for any other purposes. -Place to shade and avoid exposure to sunshine
Thermaltake recommends the following steps to be taken after completing your water loop setup
It is strongly recommended to use market proven pre-mix coolant, such as Thermaltake Coolant 1000. It offers great performance while preventing the entire cooling system – copper, brass, nickel, aluminum, and steel – from corrosion.
Fill the reservoir with coolant and cycle the power on and off several times while the pump pushing the coolant into the loop.
DO NOT let the pump run dry, when there is no liquid entering the pump turn off your power immediately
Fill the reservoir to the top as it will prevent air from going into the pump
If necessary tilt the system slightly from side to side to bleed the air out of the loop.
Place some paper towels under fittings and joining points to test for leaks.
Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop